UniBeam Walkalong - U-Shape Wipe

TRA1301 This girder clamp provides a suspension point from the flanges of an 'I' beam. It comprises of a length of Unistrut and two square 'U' bolts each attached to cranked rectangular clamp plates. Any flange width or thickness from a rolled steel or Aluminium joist beam can be accommodated. The suspension is achieved using a TRA1801 or ERL1801 Studding Set. 

TRA1602 Wall Bracket is used to attach a track to a wall or vertical surface. The side arms are spaced 13 mm apart to allow studding or threaded rod to attach into the top channel for any of our track systems. This component has a reach of 500 mm.

Standard curved UniBeam track section, 2 m (6'6") radius x 90 degrees.

Curved UniBeam track lengths can be rolled to any required radius (min 2 m (6'6")) and to a maximum length of 5.5 m (18').

UBM1501 Deadline fixing for UniBeam.

The UBM0501 bright zinc plated joint set is used to connect two adjoining sections of track together. It comprises of two clamp plates designed to have a close fit inside the width of the channel groves. Four 10 mm set screws (located in each plate) lock the two separate track sections together.

The UBM0101 UniBeam track is an aluminium alloy extrusion, 100 mm deep x 50 mm wide. Lipped grooves located in the top and bottom of the track are joined by a thin vertical web and are designed to accept standard Unistrut channel nuts. These track section are available in lengths of up to 6.1 m (20 feet). The UBM0101 UniBeam track system has the same external dimensions as UniTrack. The running gear components are therefore also compatible with both systems.

150 mm x M12 studding is supplied with four nuts and washers including a Unistrut nut. Longer lengths of studding are available on request and can be used with our TRA1301 Girder Clamp and TRA16 Wall Bracket Set.